Azden 105UPR User Manual

Also see for 105UPR: Specifications Specifications User guide

Contents

specifications

Azden 105UPR User Manual Manual pdf 2 page image

123456 7891011121314 151617181920212223242526272826++--Operating the systemBecause this is a frequency agile system, the receiver and transmitter must both be onthe same Receive/Transmit frequency. Follow the instructions #5, 16, 24 and 27 carefully.Make sure both the receiver and the transmitter are on the same channel.105UPR ReceiverAfter installing new batteries, mount the receiver to your video camera with the suppliedshoe-mount or hook and loop fastener. Connect the output cable to the receiver and to themicrophone input on the video camera. Switch the 105UPR to “ON” and the power indica-tor (7) should come on RED. If it doesn’t, check the batteries. When the 105UPR receivesa signal from the transmitter the LED indicator will change to GREEN. If it does not, makesure both the receiver and the transmitter are on matching Receive/Transmit frequencies.15BT TransmitterPlug in the supplied microphone and clip it to your subject. The microphone should beplaced 4-12 inches from your subject’s mouth. Clip the transmitter to a belt using thesupplied belt-clip or place it in a pocket. Switch the 15BT to “ON” and the power indi-cator should come on. If it doesn’t, check the batteries. Have someone speak into themicrophone as you monitor the sound through the receiver’s phone output. If the sound isdistorted, lower the MIC level on the transmitter. If there is not enough volume, raise theMIC input level on the transmitter.15XT Plug-In TransmitterSwitch the transmitter to “ON” and the power indicator should come on. If it does not, checkthe batteries. Have someone speak into the microphone as you monitor the sound throughthe receiver’s phone output. If the sound is distorted, lower the MIC level on the transmitter.If there is not enough volume, raise the MIC input level on the transmitter.15HT Handheld Microphone/TransmitterSwitch the transmitter to “ON” and the power indicator should come on. If it does not, checkthe batteries. Have someone speak into the microphone as you monitor the sound throughthe receiver’s phone output. If the sound is distorted, lower the MIC level on the transmitter.If there is not enough volume, raise the MIC input level on the transmitter.Important InformationLicensing of this, or any Azden wireless equipment is the user’s responsibility. The ability to receive alicense depends largely on the user’s classification, application and frequency. Contact the appropriateagency (FCC in the US) for further information.These devices comply with Part 15 of the FCC Rules. Operation is subject to the following two condi-tions: (1) These devices may not cause harmful interference, and (2( The devices must accept Andyinterference received, including interference that may cause undesired operation.Note: The manufacturer is not responsible for any radio or TV interference cause by unauthorized modifi-cations to this equipment. Such modifications could void the user’s authority to operate the equipment.These devices and their antenna(s) must not be co-located or operated in conjunction with any otherantenna or transmitter.

/ 4

Related manuals for Azden 105UPR