First things firstSetting up the Acer p700 Series Portable Navigator in your vehiclexivSetting up theAcer p700 Series Portable Navigator inyour vehicleTheAcer p700 Series Portable Navigator comes with a car mount kit and a car chargerso you can set up your device in your vehicle. Position the car mount kit on thewindscreen using the suction cup.NOTE: Some newer vehicle models may have a heat reflective shield embedded in thewindscreen. This may in some cases obstruct the GPS signal reception. If you encounter thisproblem in your vehicle, you need to purchase an external GPS antenna. For moreinformation, contact your local Acer dealer.Car mount installation remindersInstall the car mount on a surface of your vehicle:• That is smooth, and free of dirt and oil.• Where you can easily view/reach it without taking your eyes too far off theroad.• Where the device will not obscure car controls nor restrict your view of theroad.• Far from the air bag deployment area.Setting up the device on your vehicleThis section shows how to install the car mount kit on your vehicle's windscreen usingthe suction cup. For dashboard installation procedures using the self-adhesive diskrefer to theAcer p700 Series Portable Navigator Getting Started Guide.1 Clean the mounting surface with a glass cleaner and a clean cotton cloth.2 If the ambient temperature is below 15°C (60°F) warm the mounting area and thesuction cup (e.g. with a hair dryer) to ensure a strong suction bond.3 Install the car mount on the selected area.• Fix the suction cup to the selected area with the locking lever facing up.• Flip the locking lever away from you to create a vacuum between the suctioncup and the mounting surface.