First things firstAcer p600 Series Portable Navigator setupxivAcer p600 Series Portable Navigator setupUsing your new Acer p600 Series Portable Navigator for the first time is a snap.Unpack, turn on, mount, and you’re ready to go. Perform the following easyinstallation tasks to start using the device straight out of the box:1 Unpack the device2 Turn on and configure the device.3 Set up the device in your vehicle.NOTE: After powering your device on for the first time by moving the power switch to theright (see diagram above), you should not use the power switch again unless you want to do ahard reset. See "Performing a hard reset" on page 33 for more information. Instead, use thepower button at the top of the device (see diagram below).