Chapter 2 — Installation212.4 AcerISDN P10 Utility InstallationTo install the utility programs, please follow the instructions listedbelow.1. Insert the AcerISDN P10 Utility Installation Diskette orCD into drive A: (B:, or D:, etc.).2. On the task bar, press “Start” and then click “Run”. TheProgram Run dialog box will open.FIGURE 2-17: INSTALLING THE UTILITY PROGRAMSType “D:\UTILITY\SETUP” in the Run Dialog Box.Press “OK”. The InstallShield Wizard will load theAcerISDN P10 utility installation program.Press “Next>” to begin installing the AcerISDN P10Utility. Follow the instructions on the screen to completethe installation.The next section describes how to use the diagnostic program tocheck the card configuration.