AcerISDN P10 User Manual18FIGURE 2-13: ENTERING THE PATH OF WINDOWS NT DISK7. When the RAS is installed, you will see the followingscreen for configuring ISDN ports as RAS devices.FIGURE 2-14: ADDING THE ISDN PORTS FOR RAS8. Press “OK” to select “ISDN1-NTWANMP” as one of the“RAS Capable Devices”, you should then see thefollowing screen.

AcerISDN P10 User Manual18FIGURE 2-13: ENTERING THE PATH OF WINDOWS NT DISK7. When the RAS is installed, you will see the followingscreen for configuring ISDN ports as RAS devices.FIGURE 2-14: ADDING THE ISDN PORTS FOR RAS8. Press “OK” to select “ISDN1-NTWANMP” as one of the“RAS Capable Devices”, you should then see thefollowing screen.

about this manual

Introduction

The AcerISDN P10 ISDN Card

AcerISDN P10 Features

Before Installing

Installing the ISDN Card

Installing the AcerISDN P10 Drivers

AcerISDN P10 Utility Installation

the diagnostic program

Troubleshooting

Troubleshooting Procedures

APPENDIX A

Acer ISDN P10 User Manual

AcerISDN P10


Contents about this manual Table Of Contents Introduction The AcerISDN P10 ISDN Card AcerISDN P10 Features Before Installing Installing the ISDN Card Installing the AcerISDN P10 Drivers AcerISDN P10 Utility Installation the diagnostic program Troubleshooting Troubleshooting Procedures APPENDIX A	AcerISDN P10 User Manual18FIGURE 2-13: ENTERING THE PATH OF WINDOWS NT DISK7. When the RAS is installed, you will see the followingscreen for configuring ISDN ports as RAS devices.FIGURE 2-14: ADDING THE ISDN PORTS FOR RAS8. Press “OK” to select “ISDN1-NTWANMP” as one of the“RAS Capable Devices”, you should then see thefollowing screen. Previous Next / 37