87Drive(s) - There is no default setting for this field. You must select thedrives for the configured array. When this field is selected, a pop-upwindow will display all the available physical drives with check boxes.Use the arrow navigation keys and press to select or deselectthe drive or drives to be put into the array. Press when done.If you select Mirror mode as the array type, you must select two drivesto be in the array. This pop-up window will appear only whenconfiguring RAID 0 (Stripe) and RAID 1 (Mirror) arrays. A RAID 10 arraycontains drives in each Stripe of the array and only two drives areallowed in each stripe. The maximum amount of Stripes is limited tofour.Stripe Size - This field applies to Stripe mode arrays only. By default,an array is set up with 64 KB stripes. Edit this field to change thedefault stripe size. The size options are:• 32 KB• 64 KB• 128 KB• 256 KB• 512 KB• 1024 KB• 2048 KB• 4096 KBYou cannot change the Stripe size of an array that has alreadybeen configured.Bootable - This determines which of the configured arrays should beused for booting the system. The options are YES or NO.You can select the boot device from the system BIOS Setup. Only onearray is allowed to be bootable in a system.Drive Selection Box[ ] Cntlr 0 - Primary Master[ ] Cntlr 0 - Primary Slave[ ] Cntlr 0 - Secondary Master[ ] Cntlr 0 - Secondary Slave
