System Housing2-232.4 Installing a Hot-swappable SCSI DriveRemove all jumper connectors on the SCSIdrive before installing it into the system. Also,for Single-Ended (SE) SCSI drives, remove theterminator jumper before connecting the SCSIdrive to the system. For the location of thejumper connectors and the terminator jumper,please refer to your hard drive’s instructions ormanual.The system supports up to eight hot-swappable drive trays.Follow these steps to install a hot-swap SCSI drive:1. Open the front panel door.2. Use your finger to release the drive tray as shown below and thenpull it out.