System Housing2-195. Secure the drive with a screw. The screw hole is located on theside of the housing.6. Connect the power cable and signal cable to the external device.7. Close the left panel.To remove a 3.5-inch storage device:1. Open the front panel door and remove the left panel. See section2.2 for more information on opening the housing panels.2. Disconnect the power and signal cables.3. Detached the external device by removing the screw located onthe side and then gently pulling out the device.4. Remove the four screws and detach the 3.5-inch drive from thedrive guide.