Step 8 Connect to the ARMC/2 from a Client SystemIn order to connect to the ARMC/2 card, you must access the ARMC/2 from anothersystem on the same network. This document refers to this other system as the clientsystem. To do this, you must know the ARMC/2 card’s IP address. If you have installedthe ARMC/2 on a network that uses DHCP, you can search the network for the ARMC/2card. To locate and find out its IP address, you must run ARMC2RMseek Locator.Note: To get or set the IP address on your ARMC/2 card in a Windows 2000 environment, youcan also run the ARMC2ConfigApp program on the host system. See Appendix B,ARMC2ConfigApp for more information on how to use the ARMC2ConfigApp program.Note: Make sure that you have already installed the ARMC/2 Windows Software Componentson the system that you want to use to locate the ARMC/2 card.Follow the steps in the table below to connect to the ARMC/2 from a remote clientsystem:Step Description1 Locate the ARMC2RMseek Locator program on your remote client system. Run theARMC2RMseek Locator program by double left clicking on it.Path : Press “Start” -> Programs -> ARMC2 Remote Tools -> ARMC2RMseek2 Left click on the Next button when you see this screen.Cont’dChapter Two : Installing Your ARMC/2 Card 23