ARMC/2 Card Remote Recovery Application (RRA), ContinuedStep DescriptionThe Active Cards in Recovery Mode screen appears and starts to search for ARMC/2 cards inRecovery Mode.Left click the ARMC/2 card’s MAC address that you want to configure.The Active Cards in Recovery Mode buttons are explained in the table below:Button DescriptionStop The Stop button allows you to stop searching the network for active cards inRecovery Mode.Refresh The Refresh button allows you to start searching the network again for ARMC/2cards’ MAC addresses in Recovery Mode.Select The Select button allows you to specify the highlighted ARMC/2 card’s settings. Youcan specify the ARMC/2 card’s MAC, IP, Network Mask, and Gateway addresses asshown in the following step.1Cancel The Cancel button allows you to cancel any new settings that are not saved.Cont’dARMC/2 User’s Guide126