AcerRouter 700 Series User Guide 3-23For all other switch types, no additional SPID information is required.If your switch type is Permanent 64K or Permanent 128K, no additionalinformation is required.Step 5 Select APPLY to add the connection profile to the AcerRouter 700’sdatabase, or select ADVANCED for more options and proceed to the nextsection.The following ISDN Port Configuration options appear when you click the Advanced button on the previous screen.This selection tells the AcerRouter 700 if it requires to validate an incoming data callby examining the ISDN sub-address associated with that call.Step 6 Set the following parameters:Ignore Sub-Address, if any: For an incoming data call if you want to ignore the called party sub-address.Require Sub-Address for Data Calls: If you require and incoming datacall to contain the called party sub-address, party or extension number toaccept an incoming call.Sub-Address: Enter the sub-address for the call to be accepted.Step 7 Click OK.Note: For the sub-address to operate correctly, all entries for any type of connection profile (Single dial-in user and office-to-office) must all be configured forsub-address operation.Configuring a Dial-in User ProfileStep 1 Select Connection Profiles from the menu:Configuration - Connection ProfilesInformation about each dial-in user who is allowed access is stored in a“connection profile.” When you select Connection Profiles, the Connection Profile Summary screen appears only if you have existing ConneIncoming Sub-AddressRequire Sub-Address for Data CallsPort ConfigurationISDNCANCEL OKOptionsIgnore Sub-Address, if anySub Address