3-14 AcerRouter 700 Series User GuideConfiguring for Remote Office AccessIn order for the local LAN to access a remote LAN, you need to configure a connection profile for the router on each site (the remote router and the local router).Note that the remote site does not have to have a Acer Netxus router, and may not beconfigurable by the local administrator. In either case, make sure the configuration ofthe AcerRouter 700 matches the requirements of the remote site.ISDN ConfigurationTo configuring the ISDN interface for Remote Office connectivity, follow these steps:Step 1 Select Access to/from Remote Site in the SMART Configuration screen. If you want to share NetWare resources on this connection, select ShareNetWare(IPX) Resource also. Click NEXT.Note: The SMART Customization screen displays the very first time you invokethe SMART tool. To return to this screen, select Customize User Interface from theSMART menu.Step 2 If you have already configured your ISDN interface, skip to Step 7. Otherwise, configure your ISDN interface now. Select ISDN from the menuConfiguration - WAN Interfaces - ISDNStep 3 The following screen appears.Step 4 Select your ISDN Switch Type from the pull-down list. Your ISDN service provider will tell you what switch type you have.Step 5 After you select your ISDN Switch Type, you may be required to enter“Directory Phone Number 1” and “Directory Phone Number 2”, or “SPID1” and “SPID2.”Simple Multifunction Access configuRation ToolBasic Internet AccessInternet Access with Advanced IP ConfigurationAccess to/from Remote Site (e.g., Branch Office)Dial-in Access for Off-Site UsersShare NetWare(IPX) ResourceSelect one or more items to be configured during this management sessionNextADVANCEDISDN Switch TypeDirectory Phone Number 1Directory Phone Number 2Port ConfigurationAPPLYISDNAuto-detect (North America only)