explanation to configure the AcerRouter 101/201.Chapter 5 TroubleshootingThis chapter provides the solutions to problems occuring during installation andoperation of the AcerRouter 101/201. Please check the following to solve problems.Problem & Symptom Possible cause & SolutionHardware-The LAN Tx/Rx LED is offModem is not able to dial outCheck all the connections and make sure that they are well connected.Make sure that your hub/switch is correctly connected to “ Hub” , or your PC to “ Node” .“ Hub” and “ Node” can not be used at the same time.Make sure that your Ethernet card is installed properly.Make sure all the physical connections are well-connected and the Modem is poweredon.Make sure a working phone line is connected to the Modem.The number may need to be added with prefix such as “ 0,” to get an outside line. Thecomma stands for the connection waiting time.I Can’ t browse to the IP Gateway Check the TCP/IP setup on your PC.Run “ winipcfg” under Windows 95/98 prompt DOS orrun “ Ipconfig” under Windows NT prompt DOS. The PC should have an IP address of192.168.1.x (where “ x” is from 1 to 254.).If you use fixed IP, you have to set client station IP address in the range of 192.168.1.2~ 192.168.1.252 except 192.168.1.100 ~ 192.168.1.149, default gateway as192.168.1.1 and DNS IP as your ISP’ s DNS IP.If the computer has previously used Dial-up networking for Internet access, you have tomake the following changes:l Click Start, Setting and Control Panelsl Double click the Internet icon and then click Connection tab