OneStart

Menu

Acer 101/201 User Manual

Also see for AcerRouter 101: User manual

Page 1 previewPage 2 previewPage 3 previewPage 4 previewPage 5 previewPage 6 previewPage 7 previewPage 8 previewPage 9 previewPage 10 previewPage 11 previewPage 12 previewPage 13 previewPage 14 previewPage 15 previewPage 16 previewPage 17 previewPage 18 previewPage 19 previewPage 20 previewPage 21 preview
Contents
  1. THE FEDERAL COMMUNICATIONS COMMISSION STATEMENT
  2. Table Of Contents
  3. CHAPTER 1 1.1 ABOUT THIS MANUAL
  4. OUTER 101/201
  5. BEFORE YOU START
  6. AcerRouter 201
  7. QUICK INSTALLATION
  8. ETTINGS
  9. SETTINGS
  10. ADVANCED CONFIGURATION
  11. Modem1 Setting
  12. Modem2 Setting
  13. Device Admin Setting
  14. Status Monitor
  15. P ROGRAM VIA C ONSOLE C ABLE
  16. TROUBLESHOOTING
  17. SPECIFICATIONS
  18. GLOSSARY
Acer 101/201 User Manual Manual pdf 14 page image
1. Connect one end of the RS-232 DB25-to-RJ45 cable° ]included in thepackage° ^ to the modem/ISDN TA and the other end to the RJ-45 serialport labeled COM 1 on the back of the AcerRouter 101. Go to Step 2. Forthe AcerRouter 201, connect one end of RJ-11 cable to wall RJ-11 outletand the other end to the RJ-11 port labeled "Line" on the back of theAcerRouter 201. Go to step 4.Note:The AcerRouter 101/201 has only one standard 10/100Base-T port.But there are two connectors – one labeled “ Hub” and one labeled“ Node” – that users can choose to use. Only one connectorshould be used at one time.2. Connect phone line to the modem/ISDN TA.3. Connect power adapter to the modem/ISDN TA and turn on the power. Wesuggest that one single modem be connected and configured first, and if anadditional modem is required, repeat the previous procedure for setting upthe first modem/ISDN TA.4. Use standard “ straight” twist-pair Ethernet cables to connect your currenthub/switch to the “ Hub” port or personal computer to the “ Node” port.5. Plug the AcerRouter 101/201 power adapter outlet, then plug the powersupply output cable into the power connector on the rear of the unit. ThePower LED should be lit immediately.3.2 Client-side Network SettingsAfter installing the AcerRouter 101/201 hardware, please follow the proceduresbelow to configure the units:1. Choose a computer in LAN to configure the AcerRouter 101/201. OnWindows 95 desktop, double click “ My Computer” .
/ 44
Related manuals for Acer AcerRouter 101
Acer AIR-104 User Manual first page preview
Acer AIR-104 User Manual
Acer 700 Series User Manual first page preview
Acer 700 Series User Manual
Acer Predator Connect W6 User Manual first page preview
Acer Predator Connect W6 User Manual
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved