Installation, Administration and MaintenanceAastra Telecom Page: 45 (47)This EUT has been shown to be capable of compliance for localized specificabsorption rate (SAR) for uncontrolled environment/general populationexposure limits specified in ANSI/IEEE Std. C95.1-1992 and had been testedin accordance with the measurement procedures specified in FCC/OETBulletin 65 Supplement C (2001) and IEEE 1528-2003.Industry Canada (Canada only)Operation of this device is subject to the following two conditions: (1) thisdevice may not cause interference, and (2) this device must accept anyinterference, including interference that may cause undesired operation ofthe device.Privacy of communications may not be ensured when using this telephone.Exposure to Radio Frequency (RF) Signals:The wireless phone is a radio transmitter and receiver. It is designed andmanufactured not to exceed the emission limit for exposure to radiofrequency (RF) energy set by the Ministry of Health (Canada), Safety Code 6.These limits are part of comprehensive guidelines and established permittedlevels of RF energy for the general population. These guidelines are basedon the safety standards previously set by international standard bodies.These standards include a substantial safety margin designed to assure thesafety of all persons, regardless of age and health.This device and its antenna must not be co-located or operating inconjunction with any other antenna or transmitter.This device has been shown to be capable of compliance for localizedspecific absorption rate (SAR) for uncontrolled environment / general publicexposure limits specific in ANSI/IEEE C95.1-1992 and had been tested inaccordance with the measurement procedures specified in IEEE 1528-2003.5.2 Communications Regulation Information for RFP 32 or RFP34 (NA)FCC Notices (U.S. Only)This device complies with part 15 of the FCC Rules. Operation is subject tothe following two conditions: (1) This device may not cause harmfulinterference, and (2) this device must accept any interference received,including interference that may cause undesired operation.Modifications not expressly approved by this company could void the user'sauthority to operate the equipment.