ACME Inferno User Manual

ACME Inferno User Manual Manual pdf 2 page image

1. IntroductionThank you for purchasing Wild Tech’s Inferno. Inferno is a unique projector creating flameeffects to produce a blazing inferno. It's a great effect to set any venue on fire, perfect forclubs, pubs, bars, parties, etc.2. Safety InstructionWARNING♦ Please keep this User Guide for future consultation. If you sell the unit to another user,be sure that they also receive this instruction booklet.♦ Unpack and check carefully there is no transportation damage before using the unit.♦ Before operating, ensure that the voltage and frequency of power supply match thepower requirements of the unit.♦ It’s important to ground the yellow/green conductor to earth in order to avoid electricshock.♦ The unit is for indoor use only. Use only in a dry location.♦ The unit must be installed in a location with adequate ventilation, at least 50cm fromadjacent surfaces. Be sure that no ventilation slots are blocked.♦ Disconnect mains power before fuse/lamp replacement or servicing.♦ Replace fuse/lamp only with the same type.♦ Make sure there is no flammable materials close to the unit while operating as it is firehazard.♦ Use safety cable when fixes this unit.♦ Maximum ambient temperature is TA: 40℃. Don’t operate it where the temperature ishigher than this.♦ Unit surface temperature may reach up to 85℃. Don’t touch the housing bare-handduring its operation. Turn off the power and allow about 15 minutes for the unit to cooldown before replacing bulb or serving.Please read carefully the instruction, which includes important informationabout the installation, usage and maintenance.♦ In the event of serious operating problem, stop using the unit immediately. Never try torepair the unit by yourself. Repairs carried out by unskilled people can lead to damageor malfunction. Please contact the nearest authorized technical assistance center.Always use the same type spare parts.♦ Don’t connect the device to any dimmer pack or power pack.♦ Do not touch any wire during operation as high voltage might be causing electricshock..Warning♦ To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain ormoisture.♦ Never touch bulb with bare fingers as it is very hot after using.♦ Hot lamp explosion hazard. Do not open the unit within five minutes after switching off.♦ Do not start on the unit without bulb enclosure or housing are damaged.♦ The housing, the lenses, or the ultraviolet filter must be replaced if they are visiblydamaged.♦ Do not look directly at the light while the bulb is on.CautionThere are no user serviceable parts inside the unit. Do not open the housing or attemptany repairs yourself. In the unlikely event your unit may require service, please contactyour nearest dealer.Rigging the fixturesThe unit should be mounted via its screw holes on the bracket. Always ensure that theunit is firmly fixed to avoid vibration and slipping while operating. Always ensure that thestructure to which you are attaching the unit is secure and is able to support a weight of10 times of the unit’s weight. Also always use a safety cable that can hold 12 times of theweight of the unit when installing the fixture.The installation must be carried out by qualified service people only. The device shouldbe installed out of reach of people and outside areas where persons may walk by or beseated.

/ 4

Related manuals for ACME Inferno