3onedata IPS215 Series Quick Installation Manual

Also see for IPS215 Series: Quick installation guide

3onedata IPS215 Series Quick Installation Manual Manual pdf 2 page image

Check if the DIN-Rail mounting kit is installed firmly.Step 1Insert the bottom of DIN-Rail mounting kit (one sideStep 2with spring support) into DIN-Rail, and then insertthe top into DIN-Rail.Tips:Insert a little to the bottom, lift upward and then insertto the top.Check and confirm the product is firmly installed onStep 3DIN-Rail, then mounting ends.【Disassembling DIN-Rail】Device power off.Step 1After lift the device upward slightly, first shift out theStep 2top of DIN-Rail mounting kit, and then shift out thebottom of DIN-Rail, disassembling ends.Notice before power on: Power ON operation: First insert the power supplyterminal block into the device power supply interface,and then plug the power supply plug contact and poweron. Power OFF operation: First, remove the power plug,and then remove the wiring section of terminal block.Please pay attention to the above operation sequence.【Power Supply Connection】The serious of switches top panel provide3-pin 7.62mm pitch industrial terminalblocks, support 1 DC power input, with anti - reverseconnection function. Voltage range: 48VDC (45~55VDC). Thepin definitions of power supply are shown as follows:Pin No. Pin Definition Description1 V+ Positive power input2 FG Shell Ground3 V- Negative power input【DIP Switch Settings】The serious of switches panel provide 4-pin DIPswitch for function setting, where "ON" is enablevalid terminal. DIP switches definition as follows:DIP Definition Operation1 Flow control Set the DIP toON2 100M copper port forced 10M Set the DIP toON3 VLAN (ports 5 and 1-4 cancommunicate with each other,but ports 1-4 cannotcommunicate with each other)Set the DIP toON4 Reserved -【Checking LED Indicator】The device provides LED indicators to monitor the deviceworking status with a comprehensive simplifiedtroubleshooting; the function of each LED is described in thetable as below:LED Indicate DescriptionPWRON PWR is connected and runningnormallyOFF PWR is disconnected and runningabnormallyRUN ON/OFF The device is running abnormallyBlinking The device is running normallyPOE（1-4）ON POE ports supply electricity forother devices normallyOFF POE port is not powering otherLED Indicate DescriptiondevicesLink/Act（1-5）ONThe Ethernet interface hasestablished an active networkconnectionBlinking The Ethernet interface is in anetwork activity state.OFFThe Ethernet interface has notestablished an active networkconnection.【Specification】Panel100M fiber port 100Base-FX, interfaces supportSC/ST/FC optional100M copper port 10/100Base-T(X) self-adaptingRJ45 port, half/full duplexself-adapting or compulsiveworking mode, supportMDI/MDI-X self-adapting100M PoE port 10/100Base-T(X) self-adaptingRJ45 port, half/full duplexself-adapting or compulsiveworking mode, supportMDI/MDI-X self-adapting, themaximum power of single PoEport is 30WPOE pins V-, V-, V+, V+ arecorresponding to Pin 1, 2, 3, 6Indicator Running Indicator, PortIndicator, Power SupplyIndicator, PoE IndicatorSwitch PropertyBackplane bandwidth 1.6GPacket buffer size 1MbitMAC Address Table 2KPower Supply

/ 3

Related manuals for 3onedata IPS215 Series