2-4Network diagramFigure 2-1 Network diagram for TFTP configurationsConfiguration procedure1) Configure the TFTP server (PC)Start the TFTP server and configure the working directory on the PC.2) Configure the TFTP client (switch).# Log in to the switch. (You can log in to a switch through the Console port or by telnetting the switch.See the Login module for detailed information.)If available space on the Flash memory of the switch is not enough to hold the file to be uploaded, youneed to delete files not in use from the Flash memory to make room for the file, and then upload the fileagain. The files in use cannot be deleted. If you have to delete the files in use to make room for the fileto be uploaded, you can only delete/download them through the Boot ROM menu.# Enter system view system-view[Sysname]# Configure the IP address of a VLAN interface on the switch to be 1.1.1.1, and ensure that the portthrough which the switch connects with the PC belongs to this VLAN. (This example assumes that theport belongs to VLAN 1.)[Sysname] interface Vlan-interface 1[Sysname-Vlan-interface1] ip address 1.1.1.1 255.255.255.0[Sysname-Vlan-interface1] quit# Download the switch application named switch.bin from the TFTP server to the switch. tftp 2.2.2.2 get switch.bin switch.bin# Upload the switch configuration file named config.cfg to the TFTP server. tftp 2.2.2.2 put config.cfg config.cfg# After downloading the file, use the boot boot-loader command to specify the downloaded file(switch.bin) to be the startup file used when the switch starts the next time, and restart the switch. Thusthe switch application is upgraded. boot boot-loader switch.bin reboot
