OneStart

Menu

2N Indoor Touch User Manual

Also see for Indoor Touch: User guideUser guideUser guideApi guide

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Page 30 preview
Page 31 preview
Page 32 preview
Page 33 preview
Page 34 preview
Page 35 preview
Page 36 preview
Contents
  1. product overview
  2. 1. Product Overview
  3. Table Of Contents
  4. product description
  5. differences between models
  6. terms and symbols
  7. safety precautions
  8. status led
  9. 3. 2N® Indoor Touch Configuration
  10. Table Of Contents
  11. factory reset
  12. launcher configuration
  13. home screen
  14. device upgrade
  15. 4. 2N® Helios IP Mobile Configuration
  16. Table Of Contents
  17. application description
  18. notification in 2n® indoor touch environment
  19. application configuration
  20. connection to 2n® helios ip
  21. power supply
  22. troubleshooting
2N Indoor Touch User Manual Manual pdf 14 page image
142N TELEKOMUNIKACE a.s., www.2n.cz®1.2.Use any 12V/2A DC power adapter connected to the terminal board (see thefigure).Use an Ethernet cable connected to a PoE supply or PoE supporting Ethernetswitch/router.A successful operation is indicated by a status RGB LED or LCD display.PoE Supply ConnectionUse a standard straight RJ-45 terminated cable to connect to the2N Indoor Touch®Ethernet. The device supports the 10BaseT and 100BaseT protocols. The Ethernetconnection state is indicated by the LEDs placed on the RJ–45 connector.Refer to for the factory settings of the3.3 Launcher Configuration 2N Indoor Touch®Ethernet interface.Licence Limitations2N Indoor Touch® can contain time-limited software licences. Refer to 3.3 Launcherfor details.ConfigurationFirmware UpgradeWe recommend you to upgrade the firmware during installation.2N Indoor Touch®Refer to for the latest FW version. Refer to for thewww.2n.cz 3.4. Device Upgradefirmware upgrade procedure.CautionFactory reset results in a change of the Ethernet interface configuration!A defective Ethernet cable may lead to a high packet loss in the Ethernetand subsequent instability and poor video call quality!WarningConnection of a defective or improper power adapter may lead to atemporary or permanent failure of the 2N Indoor Touch® unit!
/ 36
Related manuals for 2N Indoor Touch
2N Indoor Touch 2.0 API Manual first page preview
2N Indoor Touch 2.0 API Manual
This manual is suitable for:
Indoor Touch
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved